DGinLZ
Sr. Contributor
"Deposit June 2020 with Mike Furman, March 2021 allocation, 3300, 15 April 2021,Shadow Grey 2LT, Z51 Coupe, Mag ride, red/blk interior GT2"
Last Activity: Today, 05:18 PM
Joined: 08-06-2020
Location: NW Burbs of Chicago
-
The QuickJacks are well, very quick to use.... -
I have the Paragon screens and have seen no increase in operating temperature post screen installation. This includes extended operation at >90F ambient....Leave a comment:
-
Can any setting be programmed in MyMode or Z Mode to inhibit V4 or, from a mode perspective, must the car be in track?...Leave a comment:
-
The 5000 EXT is the correct model. I bought them last spring when they were also on sale. They come with rubber pucks that adjust to allow then to be...Last edited by DGinLZ; 06-12-2021, 02:08 PM.Leave a comment:
-
Looking forward to it Charles.Leave a comment:
-
The Grey Ghost Rises; Quick Jacks, Paragon radiator guards, ACS 1VM Front Splitter
The Grey Ghost rose today on my Quick Jack’s (5000 ext) for the first time. What a time saver these are, they work brilliantly and are easy to setup...
Last edited by DGinLZ; 06-12-2021, 09:03 PM. -
My 21 produced in May had quite a bit of water in drivers side tower when it arrived at the dealer, 7 days after it was produced. I installed the cov...Leave a comment:
-
Mine are installed with both the rivets and tape. They sit very flush against the body. Looks cool too.....
Leave a comment:
-
God bless. Im thankful your wife is OK.Leave a comment:
-
Interesting. I did not make that change yet my metadata was not "fixed".Leave a comment:
-
I would suspect that they definitely add downforce and increase drag a little. Probably only noticeable either with a top speed run or track use. Its...Leave a comment:
-
A little math error in the timeline tracker. My wait time was; Jun 2020 deposit, May 2021 delivery. Total time was 1 day short of 11 months.Leave a comment:
-
The install uses three (3) rivets and two (2) strips of double sided trim tape. It requires drilling into the existing spoiler to locate the rivets. Its...Leave a comment:
-
Charles, Was planning to this weekend but I realized that you need to cut down the supplied lifting blocks to fit under the car as it sits so low. I plan...Leave a comment:
-
Installed ACS Z51 Wickers
Added the ACS wickers to the Grey Ghost yesterday. Love these. Very easy install. Perfect fit and paint match to OEM Z51 spoiler. Not inexpensive...
-
Light Install completed today on the Grey Ghost. About 2.5 hrs of labor. Not for the faint of heart but not technically challenging. Love the outcome...
Leave a comment:
-
Light Install complete. About 2.5 hrs of labor. Not for the faint of heart but not technically challenging. Love the outcome highly recommend a good set...
Leave a comment:
-
It’s a lot of trim inside behind the driver and a lot on the rear desk lid. Worst part is climbing around inside the engine bay to fish the new cable....Leave a comment:
-
I received the paper work and rebate checks this week from Criswell to allow me to get the car registered and titled in the great state of Illinois. The...Leave a comment:
-
Jeez guys this is very unfortunate. I’ll say prayers that BGA gets back up and running as soon as possible.Leave a comment:
No activity results to display
Leave a comment: